The following tutorial shows you how to fit the JR Filters induction kit to your Suzuki Swift Sport (ZC31S). The kit should also fit the UK 1.3L and 1.5L non-sport Swifts too.
JR Filters are the only filters that will protect your engine against particles as small as 2.8 microns, giving 99% filtration.
With these filters fitted, power is increased and fuel consumption reduced.
JR Filters are TUV approved and come with a lifetime guarantee to the first owner.
The filters are washable, which means they are always reusable; no more changing and no need for disposal.
You can purchase the Swift Induction Kit from our PartBox online shop.
Please Notes: Cable Ties are packed into the filter head – check before fitting
Tools Required to Fit:
- Ratchet
- 10mm deep socket
- 13mm socket
- Phillips screwdriver
Induction Kit Installation Instructions:
1) Open bonnet.
2) Remove engine cover (this is push fit so comes off easily).
3) Remove rubber feed pipe (this is push fit so comes off easily).
4) Remove front half of air box: Undo the bolt on RHD side of engine, and the bolt on the left hand side of the inlet manifold. Remove both studs at the front of the engine (these are what the engine cover clipped to). Using a socket remove the plastic intake pipe holder from the front panel (keep the bolt).
5) Using the Phillips screw driver loosen the jubilee clip holding the rubber intake pipe to the throttle body (this will allow you to twist the rear section of the air-box around). Using the Phillips screw driver and socket CAREFULLY remove the solenoid and Airflow sensor, then pull off the air box lid and rubber intake elbow.
6) Try the supplied JR intake elbow against the throttle body, if this does not fit, remove the metal section and refit to your existing elbow using jubilee clips (the two pictures above show us performing this mod on our own car).
7) Fit air flow sensor into rubber JR filter pipe (shown in image above left), using two of the supplied cable ties secure the sensor (shown in image above middle) then fit the pipe to the elbow using supplied jubilee clip (shown in image right).
Fit filter head onto intake pipe using supplied jubilee clips (shown in image above left) attach bracket to filter head and fit onto front panel using the original bolt (shown in image above right).
9) Using the remaining cable tie secure the solenoid to the throttle body elbow.
