Exedy Pull Clutch clip repair/install

Those helpful guys at Exedy designed a great system with their patented Pull clutch mechanism. However, occasionally this set-up goes wrong, or gets dislodged whilst fitting. Repair parts are available, and here is how they should be fitted:

The procedure for fitting a replacement ring mechanism to a Pull Type Clutch Cover

PART REF: RING

The part ref ‘RING’ is made up of two components;

Wedge collar (1) and a Wire ring (2).

BLOG 1

These replacement parts will fit all pull type clutch covers, apart from the Mitsubishi EVO IV – X.

FITTING PROCEDURE:

1 – Place the Wedge collar (1) over the centre ring.

2 – Press down.

3 – Turn the cover over and place the wire ring around the retaining clips.

4 – Ensure that the wire ring is seated correctly.

BLOG 2 BLOG 3 BLOG 4 BLOG 5

 

PART REF: RING_W

The part ref ‘RING_W’ is made up of three components; Wedge collar (1), Wire ring (2) and two Wave springs (3).

 

BLOGGGBLOGGGG

These replacement parts fit the Mitsubishi EVO IV – X.
FITTING PROCEDURE:

1 – Place the Wave springs (3) over the centre ring.

2 – Place the Wedge collar (1) over the Wave springs (3) and press down.

3 – Turn the cover over and place the wire ring around the retaining clips.

4 – Ensure that the wire ring is seated correctly.

BLOG 7 BLOG 8 BLOG 9 BLOG 10

Leave a Reply

Your email address will not be published. Required fields are marked *